Loading... Please wait...


Our Newsletter

Power amplifier AP2000 for DJI phantom etc radio

  • Image 1
Calculated at checkout

Product Description

Power amplifier AP2000 for DJI phantom etc radio
Power amplifier AP2000 for DJI phantom etc radio :

DJI phantom Power amplifier AP2000 is special developed for DJI phantom radio,
Can enhance the remote distance of at least 1.7 times.
( phantom radio control around 1000meters, add this amplifier, control distance go up more than 1700 meters).

This product not only enhance the control of the distance, but also to suppress other 2.4G clutter interference, improve the reliability of close control. Whether you are to fly away, or just flying at close range, this product can improve aircraft flying against interference!
 AP2000 is a 2.4G 2000mW power amplifier module, which not only can be used for remote control wizard, but also can be used for all kinds of other devices using the 2.4G , for example: Futaba, JR, etc. WFLY 2.4G remote control or 2.4G router.

AP2000 technical parameters:

Receive Gain: 10dB
Transmit Gain: 11dB
Acceptable noise factor: ≤ 3.0dB
Input Power Range: 4dBm-20dBm
Maximum transmit power: 33dBm; 2W (plus input power amplifier power)
Input voltage :3.7-5 .5 V
Module Weight: 15g (when excluding antenna)
Dimensions: 36mm x 26mm x 4.8mm
Standard antenna gain: 6dBi

Shipping package included:
1x AP2000 power amplifier module
1x 6dBi omnidirectional antenna
1x Adapter
1x modified feeder


application instructions:
1.  remove remote control original antenna , remove antenna cable with output modules
2.  on the original feeder socket remote antenna holder, or drill hole to fix it .
3.  Place the feeder inputs inserted in the original remote control antenna signal output port (phantom radio  and Futaba controller directly plug and play)
4  The AP2000 amplifiers installed in the feeder seat, and installed omnidirectional antenna
5.  provides a 3.7-5.5V power  for the AP2000

power providing Method for the AP2000 :
If you are using a phantom remote control , ok to directly get power from battery +5V UBEC , because phantom use four pc 1.5V battery, when fully charged voltage is 6.0V, exceed the rated voltage 5.5V, so you still need to add UBEC .
If you are using a Futaba remote control, please purchase separately a 5V UBEC to lower voltage for ap2000.
Of course, you can also use a separate lithium battery +5 V UBEC to power ap2000.

* AP2000 power amplifier input plug is JST female plug, you need to notice ,


installing reference pic:


Find Similar Products by Category

Add to Wish List

Click the button below to add the Power amplifier AP2000 for DJI phantom etc radio to your wish list.

You Recently Viewed...